Need help?Do you have a question about the Michell Instruments Cermet II and is the answer not in the manual?
General| Brand | Michell Instruments |
|---|---|
| Model | Cermet II |
| Category | Measuring Instruments |
| Language | English |
Details electrical safety precautions for instrument operation.
Outlines safe operating pressure limits and warnings.
Information regarding hazardous materials used in construction.
Guidance on who should maintain the instrument and where to find contact info.
Recommends calibration intervals and procedures.
States compliance with relevant EU directives.
Lists key features and capabilities of the Cermet II hygrometer system.
Step-by-step guide for unpacking the hygrometer and accessories.
Instructions for carefully unpacking the dew-point transmitter.
Procedure for unpacking the monitor unit.
Details the contents of the accessories pack.
Lists all standard components included with the Cermet II system.
Describes the monitor's display, units, and alarm indications.
Identifies controls and their functions on the monitor's front panel.
Explains how to prepare and connect the transmitter cable.
Provides general guidance on mounting the transmitter safely.
Details mounting the transmitter using a sample block and gas connections.
Instructions for direct mounting of the transmitter into a pipe or duct.
Steps for mounting the transmitter with a process connection adapter.
Guide for panel mounting the Cermet II monitor unit.
Covers power supply connections for the monitor.
Specific instructions for low voltage power supply connections.
Details connecting an optional pressure transducer.
Explains the diagram and table for transmitter cable connections.
How to use DIP-switches to lock configuration settings.
Guide to changing measurement units (°C, °F, ppm, etc.).
Procedure for adjusting alarm setpoints and relay configurations.
Configuring hysteresis, make/break delays, and delay types for setpoints.
Steps to scale the analog output signal (4-20mA or 0-10V).
How to adjust the brightness of the monitor display.
Settings for ASCII RS232/RS485 communication interface.
How to enable pressure compensation for ppm readings.
Steps to configure the monitor for pressure transducer input.
Guide to manually calibrating the pressure input channel.
Procedure for calibrating pressure input using a 4-20mA source.
Manually entering pressure values for compensated ppm readings.
Provides advice on obtaining representative gas samples.
Routine calibration requirements and services offered.
Instructions for replacing the HDPE or stainless steel sensor guard.
Information on obtaining replacement bonded seals.
Detailed technical specifications for the Cermet II monitor.
Detailed technical specifications for the Cermet II transmitter.
Explains configuration codes for various functions and settings.
Lists register numbers and their functions for digital communication.
States compliance with relevant EU directives and standards.
Details compliance with the Pressure Equipment Directive.
Information on the company's commitment to recycling.
Explains compliance with the Waste Electronic and Electrical Equipment Directive.
Details compliance with the Restriction of Hazardous Substances Directive.
Outlines the terms and duration of the product warranty.
Information regarding compliance with REACH chemical regulations.
Procedure for returning instruments for service or repair.
Information on the company's calibration services and traceability.
Details the company's quality assurance standards and certifications.
Compliance information for FCC and Canadian radio interference regulations.
Form for documenting instrument returns and decontamination status.
To Next Page
