Micro Motion CDM100P - View Process Variables Using the Display; View Process Variables and Other Data Using Prolink III

• View process variables using the Field Communicator (Section 8.2.3)
8.2.1 View process variables using the display
View the desired process variable(s).
The display shows the configured display variables. For each display variable, the display
reports the abbreviated name of the process variable (for example, DENS for density), the
current value of that process variable, and the associated unit of measure (for example, G/
CM3).
If Auto Scroll is enabled, the display cycles through the display variables, showing each
display variable for a user-specified number of seconds. Whether or not Auto Scroll is
enabled, you can activate Select to move to the next display variable.
Transmitter display featuresFigure 8-1:
A. Display (LCD panel)
B. Process variable
C. Scroll optical switch
D. Optical switch indicator: turns red when Scroll is activated
E. Optical switch indicator: turns red when Select is activated
F. Select optical switch
G. Unit of measure for process variable
H. Status LED
I. Current value of process variable
8.2.2 View process variables and other data using ProLink III
Monitor process variables, diagnostic variables, and other data to maintain process quality.
ProLink III automatically displays process variables, diagnostic variables, and other data on
the main screen.
Transmitter operation
112 Micro Motion
®
Compact Density Meters (CDM)