Micro Motion CDM100P - Set up the API referral application

• Configure Velocity Damping (Section 4.5.2)
• Configure Flow Direction (Section 4.5.3)
• Configure Velocity Cutoff (Section 4.5.4)
• Configure Velocity Switch Setpoint (Section 4.5.5)
4.5.1 Configure Velocity Measurement Unit
Display OFF-LINE MAINT > OFF-LINE CONFG > UNITS > VEL
ProLink III Device Tools > Configuration > Process Measurement > Velocity > Velocity Unit
Field Communicator Configure > Manual Setup > Measurements > Velocity > Velocity Unit
Overview
Velocity Measurement Unit controls the measurement unit used to report velocity.
Procedure
Set Velocity Measurement Unit to the desired unit.
The default setting is m/sec.
Options for Velocity Measurement Unit
The transmitter provides a standard set of measurement units for Velocity Measurement Unit.
Different communications tools may use different labels.
Options for Velocity Measurement UnitTable 4-4:
Unit description
Label
Display ProLink III
Field Communica-
tor
Feet per minute FT/M ft/min ft/min
Feet per second FT/S ft/sec ft/s
Inches per minute IN/M in/min in/min
Inches per second IN/S in/sec in/s
Meters per hour M/H m/hr m/hr
Meters per second M/S m/sec m/s
Configure process measurement
38 Micro Motion
®
Compact Density Meters (CDM)