10.27 Locate a device using the HART 7 Squawk
feature
The Squawk feature causes the device to show a specific pattern on its display. You can use
this to locate or identify a device.
Restriction
The Squawk feature is available only with HART 7 connections. It is not available with ProLink III.
Procedure
1. Choose Service Tools > Maintenance.
2. Click Locate Device, then click Next.
An 0-0-0-0 pattern is shown on the display.
To return to the normal display, activate either Scroll or Select, or wait 60 seconds.
Troubleshooting
166 Micro Motion
®
Compact Density Meters (CDM)
To Next Page
Loading...
