Micro Motion CDM100P - Configure Informational Parameters

Status alerts and Status Alert Severity (continued)Table 5-1:
Alert number Alert title Default severity User can reset severity
A100 mA Output 1 Saturated Informational To Informational or Ignore only
A101 mA Output 1 Fixed Informational To Informational or Ignore only
A102 Drive Overrange Informational Yes
A104 Calibration in Progress Informational To Informational or Ignore only
A105 Two-Phase Flow Informational Yes
A106 Burst Mode Enabled Informational To Informational or Ignore only
A107 Power Reset Occurred Informational Yes
A113 mA Output 2 Saturated Informational To Informational or Ignore only
A114 mA Output 2 Fixed Informational To Informational or Ignore only
A115 No External Input or Polled Da-
ta
Informational Yes
A116 Temperature Overrange (API
Referral)
Informational Yes
A117 Density Overrange (API Refer-
ral)
Informational Yes
A118 Discrete Output 1 Fixed Informational To Informational or Ignore only
A120 Curve Fit Failure (Concentra-
tion)
Informational No
A121 Extrapolation Alert (Concentra-
tion)
Informational Yes
A122 Pressure Overrange (API Refer-
ral)
Informational Yes
A132 Sensor Simulation Active Informational Yes
A133 EEPROM Error (Display) Informational Yes
A134 Tube-Case Temperature Differ-
ence Overrange
Informational Yes
A136 Incorrect Display Type Informational Yes
5.5 Configure informational parameters
Display Not available
ProLink III Device Tools > Configuration > Meter Information
Field Communicator Configure > Manual Setup > Info Parameters
Configure device options and preferences
Configuration and Use Manual 81