Micro Motion CDM100P - Chapter 1 Before you begin; About this manual; Model codes and device types

Contents
Part I Getting Started
Chapter 1 Before you begin ............................................................................................................3
1.1 About this manual ....................................................................................................................... 3
1.2 Model codes and device types ..................................................................................................... 3
1.3 Communications tools and protocols .......................................................................................... 4
1.4 Additional documentation and resources .................................................................................... 5
Chapter 2 Quick start .....................................................................................................................7
2.1 Power up the transmitter .............................................................................................................7
2.2 Check meter status ......................................................................................................................7
2.3 Make a startup connection to the transmitter ..............................................................................8
2.4 Zero the meter ............................................................................................................................ 9
2.4.1 Zero the meter using the display .................................................................................. 9
2.4.2 Zero the meter using ProLink III .................................................................................. 10
2.4.3 Zero the meter using the Field Communicator ............................................................11
Part II Configuration and commissioning
Chapter 3 Introduction to configuration and commissioning ....................................................... 15
3.1 Default values ............................................................................................................................15
3.2 Enable access to the off-line menu of the display ....................................................................... 15
3.3 Disable HART security ................................................................................................................15
3.4 Set the HART lock ...................................................................................................................... 18
3.5 Restore the factory configuration .............................................................................................. 18
Chapter 4 Configure process measurement ..................................................................................21
4.1 Verify the calibration factors ......................................................................................................21
4.1.1 Calibration factors ...................................................................................................... 22
4.2 Configure line density measurement ........................................................................................ 23
4.2.1 Configure Density Measurement Unit ................................................................................23
4.2.2 Configure Density Damping ............................................................................................ 25
4.2.3 Configure Density Cutoff ................................................................................................ 26
4.2.4 Configure two-phase flow parameters ........................................................................ 26
4.3 Configure temperature measurement .......................................................................................28
4.3.1 Configure Temperature Measurement Unit ........................................................................ 28
4.3.2 Configure Temperature Damping .....................................................................................29
4.3.3 Configure Temperature Input .......................................................................................... 30
4.4 Configure the pressure input ..................................................................................................... 34
4.4.1 Configure the pressure input using ProLink III ............................................................. 34
4.4.2 Configure the pressure input using the Field Communicator .......................................35
4.4.3 Options for Pressure Measurement Unit ........................................................................... 37
4.5 Configure velocity measurement .............................................................................................. 37
4.5.1 Configure Velocity Measurement Unit ............................................................................... 38
4.5.2 Configure Velocity Damping ............................................................................................39
Contents
Configuration and Use Manual i