Micro Motion CDM100P

To Next Page

To Previous Page

Option Description

Informa-

tional

Actions when fault is detected:

• The alert is posted to the Alert List.

• The status LED (if available) changes to red or yellow (depending on alert se-

verity).

Actions when alert clears:

• The status LED returns to green.

Status alerts and options for Status Alert Severity

Status alerts and Status Alert SeverityTable 5-1:

Alert number Alert title Default severity User can reset severity

A001 EEPROM Error Fault No

A002 RAM Error Fault No

A003 No Sensor Response Fault Yes

A004 Temperature Overrange Fault No

A005 Velocity Overrange Fault Yes

A006 Characterization Required Fault Yes

A008 Density Overrange Fault Yes

A009 Transmitter Initializing/Warm-

ing Up

Ignore Yes

A010 Calibration Failure Fault No

A011 Zero Calibration Failed: Low Fault Yes

A012 Zero Calibration Failed: High Fault Yes

A013 Zero Calibration Failed: Unsta-

ble

Fault Yes

A014 Transmitter Failure Fault No

A016 Sensor Temperature (RTD)

Failure

Fault Yes

A017 Sensor Case Temperature

(RTD) Failure

Informational Yes

A020 Calibration Factors Missing Fault Yes

A021 Transmitter/Sensor/Software

Mismatch

Fault No

A029 Internal Electronics Failure Fault No

A030 Incorrect Board Type Fault No

A033 Insufficient Pickoff Signal Fault Yes

A037 Sensor Check Failed Fault Yes

A038 Time Period Signal Out of

Range

Fault No

Configure device options and preferences

80 Micro Motion

Compact Density Meters (CDM)

Micro Motion CDM100P - Page 86

Table of Contents

Other manuals for Micro Motion CDM100P