micro-trak MT-3000 - Page 28

28
Does Spray
Rate Register?
Y
N
Y
Y
N
Can Pressure
be Adjusted
Using “+/-”
in MAN?
Y
Y
Y
Y
NN N
Y
Y
Y
N
N
MT-3000 Troubleshooting Flow Chart
Troubleshooting (cont.)
General (cont.)
Continued from Previous Page
Y
26
Does Spray Rate
Read 655.3?
Does “+”
Increase and
“-” Decrease
Pressure?
24
Y
28
N
27
Console
On Vehicles with Two
12 Volt Batteries, Make
Sure all Power Wires Go
to Only One Battery
25
Y
Did System
Pass Pre-field
Checkout?
Y
29
Is Spray Rate
Correct in AUTO?
Y
Y
Does Flow
Rate Register?
Does Speed
Register?
Does Area
Count?
Console
Go to Box
Number 14
Go to Box
Number 7
Go to Box
Number 19
Does Area
Count?
Go to Box
Number 14
Does Servo Valve
Open and Close?
Do Servo Wires
Have Proper
Signal?
Servo Harness
Console
Plumbing
Does Area
Count?
Go to Box
Number 14
N
N
Console
Harness
Reverse Servo Wires
N
Perform Pre-field Preparation
and System Checkout
N
Minimum Flow
Rate High
Check Target
Application Calibration
Console
Does Spray
Rate Go High?
Is Spray
Rate Steady?
Is Error
at 0%
Can Spray Rate be
Reached in MAN?
Plumbing
N
NN
N
NN
According to the Manufacturer’s
Tip Chart and the Formula on page
9, Does Flow Rate, Speed, Width,
Spray Rate and PSI Check Out?
Is Total
Liquid Correct?
Is Area
Correct?
Plumbing
Go to Box
Number 15
Go to Box
Number 22
System Checks
Out OK
N
N
30