Calibration 3Flex Service Manual
4-2 Aug 2013
Calibration
This calibration and test procedure is the one used in Micromeritics’ Final Assembly Department. It is
provided as a reference so that you will be familiar with the calibration procedures and instrument tests
that are performed on the instrument during manufacture.
The methods used at the factory may differ from the methods documented in the Maintenance docu-
ments. Use the established service calibration and test procedure unless otherwise directed by a
Micromeritics Service Managers or Service Specialist.
• Product Calibration Procedure, P/N: 350-34000-76
Mechanical and Electrical Drawings
These drawings show assemblies in detail. Some parts listed in these prints may be available only as an
assembly or in a kit. Do not provide copies of these drawings to a customer.
Mechanical
Refer to the following table for a list of the mechanical prints. Double-click on the part number to view
the print.
Print Number Description
350-34000-00 Semi-final assembly
350-34001-00 Chassis assembly
350-34002-00 Card Cage
350-34003-00 Power tray assembly
350-34004-00 Base manifold assembly
350-34005-00 Elevator assembly
350-34006-00 Vacuum system assembly
350-34007-00 Pneumatic manifold
350-34008-00 Vacuum gauge assembly
350-34009-00 Cabinet heater assembly
350-34012-00 Inlet manifold assembly
To Next Page
Loading...
Need help?
General
