Command Hierarchy
After logging in, press ? + <enter> to show the 9 command groups.
System - System commands
Console - Console commands
Port - Port commands
VLAN - VLAN commands
Aggr - Aggregation commands
QoS - QoS commands
Mirror - Mirror commands
IP - IP commands
SNMP - SNMP commands
Ratelimit - Rate setup commands
Exit - Logout commands
Press ? or help to get help. The help depends on the context:
- At top level, a list of command groups will be shown.
- At group level, a list of the command syntaxes will be shown.
- If given after a command, the syntax and a description of the
command will be shown.
Entering Commands
To give any command, please key in your command and press enter.
EX,
1. Type “system” and press <enter> to get access to the system command group.
2. Type “Configuration” and press <enter> to perform “configuration”
You can type “up” and press <enter> to go back to upper level.
28
To Next Page
Loading...
