D5CUB System Board Manual
36
When the system is turned on, it performs a memory test,
and a BIOS identification and system information screen
is displayed on your monitor, as shown in Figure 4-1.
Figure 4-1: Power-Up Screen
When “Press DEL to enter SETUP” appears near the
bottom of the screen, press the <DEL> key to start the
Setup program. The main CMOS Setup utility screen
(Figure 4-2) appears, with the highlight on STAN-
DARD CMOS SETUP. Note that the Setup program
can only be activated during the boot sequence.
Section 4: The BIOS Setup Utility
To Next Page
Loading...