Backing Up/Restoring Configurations
5.
Select 1) Backup Cfg.
6. When the SyncServer finishes "Saving to USB Drive", remove the USB flash drive.
From the web interface
1.
On the WIZARDS - Backup web page, click the BACKUP button to create a backup file on
the SyncServer.
2.
Then use the SAVE AS or COPY button to download the backup file to a your workstation
or a USB device.
Restoringfrom aBackupFile
From the front panel keypad
1. Plug the USB flash drive into the 'target' SyncServer.
2. Wait 10 seconds.
3.
Press the MENU button, select 4) USB, and select 1) Restore Cfg.
4. The SyncServer reports "Restoring from USB Drive" and "Shutting down, please wait..."
5. When the SyncServer finishes rebooting, remove the USB flash drive.
From the web interface
On the WIZARDS - Restore web page, select one of the following options:
n Reset to Factory Defaults. See Restoring the Factory Default Configuration (on
page 119).
n Restore last backup from SyncServer.
n Restore backup from USB flash drive.
n Restore backup from a workstation hard-drive or network directory.
RestoringtheFactoryDefaultConfiguration
The user may wish to restore the factory default configuration in a variety of circumstances:
n When the password is lost and the Recover Password feature is disabled (Use the Hard-
ware Jumper method).
n To erase the previous configuration prior to reconfiguring the SyncServer.
n To erase site-specific information such as the IP addresses and the GPS position, prior to
sending the SyncServer off-site.
In some cases, the user may back up the current configuration of the SyncServer prior to
restoring the factory default configuration. See Creating a Backup File (on page 118).
Restoring the default factory configuration removes the current network settings. After-
wards, the user may need to configure the LAN1 port in order to use the web interface.
Using the Web Interface
To restore the factory configuration use the one of the following pages:
n SYSTEM - Factory Reset
n
WIZARDS - Restore (select Reset to Factory Defaults).
997-01520-02 Rev. G2.......................................................................... Page 119
To Next Page
Loading...
