Microsemi SyncServer S250 - ADMIN Tab; ADMIN-Web

ADMIN Tab
ADMIN Tab
Select a topic from below to learn more about the ADMIN features of the Web Interface:
ADMIN-Web
Use this page to:
n Configure the appearance and information displayed on the login page.
n Modify the behavior of the web interface.
Login Page Configuration
The settings in this section configure the Login page to:
n Display status information. This is convenient for monitoring status without logging in, par-
ticularly if LAN1 is on a private administrative network.
n Remove status and information that identifies the SyncServer from the login page. This
makes it more difficult for unauthorized users to recognize the SyncServer via its web
interface.
The login page choices are:
n
Plain: Login page does not contain any identifying text or graphics.
n
Graphic: Login page contains identifying text, graphics, and user-selected status inform-
ation.
The configurable system information includes the following choices:
n
Title: A user-determined text string at the top of the login page.
n
Time, Hostname and LEDs: The local time, the hostname, and the status LEDs.
n
NTP Status: The NTP Stratum and Reference ID.
n
Hardware Clock Status: The current Sync Source and whether the Hardware Clock is
locked.
n
GPS Receiver Status and the Satellite Count: GPS receiver is providing timing information
and the number of satellites visible.
n
Highest Severity Alarm: The name of the most recent and most severe pending alarm.
n
Version Information and Uptime: The model number, software version, and uptime since the
unit was started.
n
IP Addresses for all Configured LAN Ports: The MAC, IPv4, and IPv6 addresses of the LAN
ports.
Save Configuration Settings
Beyond the login page, the user can determine the behavior of the web pages.
Warn when Navigating without saving Changes: (Enabled by default)
n When this feature is enabled, the SyncServer sends warnings messages if the user
makes settings changes and navigates away from the page without clicking the APPLY
button. This reduces the possibility of accidentally losing unsaved changes.
n When this feature is disabled, the SyncServer suppresses these warning messages.
997-01520-02 Rev. G2.......................................................................... Page 55