Specifications
Note: In some cases, for FCC and CE EMC Radiated Emission Compliance, a ferrite EMI
suppressor (Fair Rite P/N 0444164951 or equivalent) may need to be placed on the unit end
of cables connected to the BNC Connectors. Please contact Microsemi Customer Assist-
ance (on page 3) for additional information.
VCCI Compliance Information
This is a Class A product based on the standard of the Voluntary Control Council for Inter-
ference by Information Technology Equipment (VCCI). If this equipment is used in a
domestic environment, radio interference may occur, in which case the user may be required
to take corrective actions.
Environmental
Operating Temp:0° to +50° C (+32° F to +122° F)
Storage Temp:-10° to +70° C ( 14° F to +158° F)
Humidity:0 - 95%, non-condensing
Altitude:0 - 4000 meters AMSL
WARNING: Install the SyncServer to allow adequate airflow through and around the unit.
Microsemi recommends leaving 1.4 in. (3.6 cm) above and below the SyncServer or
enough space to allow 5 CFM.
AVERTISSEMENT : Installez le SyncServer pour permettre un flux d'air autour et a tra-
vers l'unité. Microsemi recommande de laisser 1.4 in. (3.6 cm) au-dessus et au-dessous du
SyncServer ou assez d'espace pour permettre 5 CFM.
Maintainability
This unit contains no user-serviceable parts. Please return to Microsemi for servicing.
The SyncServer functions without user adjustments throughout its life span.
Page 88..........................................................................997-01520-02 Rev. G2
To Next Page
Loading...
