Microsemi SyncServer S250 - ADMIN-Alarms

ADMIN Tab
n
New User, allows new Username and password information to be entered. If Password
Recovery checkbox is selected, recovery information can be entered, and a test email can
be generated.
n
admin, allows usernames and passwords for existing users to be maintained.
Note: The Delete Selected User checkbox when checked, deletes information in the Recovery
Question fields. If the Apply button is clicked, the user information will be deleted.
Passwords
Passwords must contain six or more characters, including lower and upper case letters, or
letters and at least one number.
With password recovery enabled, the user can reset the password to a random string from
the Login page by correctly answering the password recovery question. The SyncServer
then sends an email message containing the new password to the email address supplied on
the ADMIN - Users page.
The SyncServer must have a valid SMTP Gateway addresses for password recovery to
work. If a DNS server is not available to <LAN*>, the SMTP gateway must be entered as an
IP address, not as a DNS name. If needed, contact the system administrator to obtain this
information.
See also: Changes to Passwords and User Names (see "Properties of User Names and
Passwords" on page 20)
Changing the Password and Enabling Password Recovery
1.
Enter the Old Password.
2.
Enter the New Password and Retype New Password.
3.
Select the Password Recovery checkbox.
4.
Select a Recovery Question and enter the Answer.
5.
Enter an Email Address and the SMTP Gateway's IP address or DNS name (if DNS is con-
figured for <LAN*>).
6.
(Optional) Select the Send Test Email checkbox.
7.
Click the APPLY button.
NOTE: Once applied, test question, answer, and email address data will not remain visible
on the page. The SMTP Gateway entered here is also used for email notification of alarms.
However, email addresses for alarm notification are entered on the SERVICES - Email page.
Email notification of alarms is configured on the ADMIN - Alarms page.
ADMIN-Alarms
Alarm Configuration and Notification
Use this page to view alarm status and to perform the following tasks:
n Configuring Alarm Severity (ALARM LED color).
n Manually clearing alarms.
997-01520-02 Rev. G2.......................................................................... Page 57