STATUS Button
Alarm Status Screen
Current alarm status.
Current: The total number of active alarms. Use the left/right arrows for search through the
list of alarms.
Major: List of current major alarms
Minor: List of current minor alarms
Also see ADMIN - Alarms (on page 57).
LAN Status Screens
Multiple screens, one for each network port.
State: Shows “Up” if the port is enabled and “Down” if the port is disabled.
IPv4 Addr: Shows the address of the port.
SM: Shows the subnet mask (IPv4) or scope (IPv6).
GW: Gateway address.
IPv6 Addr: The IPv6 Link local address for this port.
Also see NETWORK - Ethernet (on page 27).
Hardware Clock Status Screen
Hardware Clock and Input Reference status.
Source: (2 fields) The first field is the name of the current reference. The second field indic-
ates "Locked" when the Hardware Clock is synchronized to that reference.
HH:MM:SS H/W: The UTC or GPS time from the Hardware Clock, depending on the
"Ignore..." setting on the TIMING - HW Clock page.
GPS In: Indicates "Locked" if the GPS receiver is a valid source of time.
1PPS In: Indicates "Locked" if 1PPS In is a valid source of phase.
IRIG-B In: Indicates "Locked" if IRIG In connector has a valid source of time.
10MHz In: Indicates "Locked" if 10MHz In is a valid source of frequency.
Also see TIMING - HW Clock.
GPS Receiver Status Screen
GPS receiver status.
Status: Indicates "Locked" when the receiver has a valid timing solution.
Satellites: The number of satellites the receiver is using.
Antenna: The electrical state of the GPS Antenna. "Good" for a normal antenna load current.
"Open" for an open electrical circuit in the antenna. "Short" for an electrical short circuit.
997-01520-02 Rev. G2.......................................................................... Page 75
To Next Page
Loading...
