To Next Page

To Previous Page

24 Port Gigabit Ethernet PoE Switch – User Manual Page 35 of 72

________________________________________________________________________

Parameter description

System Priority:

System priority is used in determining the root switch, root port and designated

port. The switch with the highest priority (lowest numeric value) becomes the

STP root switch. If all switches have the same priority, the switch with the lowest

MAC address will then become the root switch. Select a vale from the drop-down

list box.

The lower the numeric value you assign, the higher the priority for this system.

Default: 32768

Hello Time:

This is the time interval in seconds between BPDU configuration message gener-

ations by the root switch. The allowed range is 1 to 10 seconds.

Default: 2

Max Age:

This is the maximum time a switch can wait without receiving a BPDU before at-

tempting to reconfigure. The allowed range is 6 to 40 seconds.

Default: 20

Forward Delay:

This is the maximum time (in seconds) a switch will wait before changing states.

The general rule: 2 * (Forward Delay – 1) >= Max Age >= 2 * (Hello Time + 1)

Default: 15

Force version:

Select RSTP or STP protocol from the drop-down list box.

Function name

RSTP Port Configuration

Function description

Enable or disable RSTP protocol on the ports that are selected and set path cost.

Microsens MS400830M User Manual

Other manuals for Microsens MS400830M