MicroStep SH-HC30 - Operation Flow of Daily Work

SH-HC30 Height Controller System Manual
4.5 Operation Flow of Daily Work
numerical control system
and height controller
power-on
When the manual rise signal
is low level, the cutting
torch moves u
p
war
d
Flow starts
Manual
Yes No
When the manual fall signal
is low level, the cutting
torch moves downwar
d
The set value of height of
“rise key” on the operation
p
anel
p
lus 1
The set value of height of “fall
key” on the operation panel
minus 1
The display displays the
current set value of height
auto-detection of "manual
/auto" status
The cutting torch adjusts the
height
automatically
accordin
g
to the set hei
g
ht
The set value of height of
“rise key” on the operation
p
anel
p
lus 1
The set value of height of “fall
key” on the operation panel
minus 1
The display displays the
current actual height
Figure 4-2 Operation Flow of Daily Work
Page
20