SH-HC30 Height Controller System Manual
Please read the safety warning and attentions to avoid any accidents due to
incorrect operations.
Please operate the machines strictly following the manual and its detailed
instructions before you install and use this machine.
All the responsibilities will be undertaken by the users if any particular illegal
utilization of SH-HC30 flame / plasma cutting torch height controller or manual is
made for it doesn’t represent our position and we refuse to admit the legal
responsibility.
The safety warning is to avoid any accidents to the human body or properties.
For any quality problems during the utilization of the SH-HC30 flame / plasma
cutting torch height controller, the customers can call the service center of our
company or authorized agents, distributors to get service and help.
It’s not allowed to copy, transmit or utilize any content of this manual without the
specific permission. Any offenders will undertake all the responsibilities for the
loss.
1.3 Warning
Please read and strictly comply with the following instructions before operating the product to reach the
design control accuracy of product and avoid any damage and accident.
Installation must be carried out by technical personnel of related industry or
having relevant experiences.
Please thoroughly read the instructions beforeinstallation.
Confirm that the selected power supply complies with the required specifications.
Installation, inserting and pulling of plugs are prohibited when the current is
switched on.
Keep away from heat for the installation position.
The controller shell must be grounded well to avoid electric shock or affecting the
controller.
The cutting board must be grounded well, and maintain a good grounding with
the controller shell in order to ensure the accuracy of height control.
Page
2
！
Note: If the controller shell and the cutting board are not grounded well, the height controller will not work
normally.
Take care when transporting and never make some fierce collision or tremble for
damage may occur.
Please don’t disconnect the SH-HC30 flame / plasma cutting torch height
controller or change its internal construction for any accidents or fault may occur.
1.4 Terms
To Next Page
Loading...
Need help?
General
