microTec
33
8.4 The “RS“ type knife holder
Stable version for Tungsten carbide conventional
steel knives with the central clamping plate
providing optimal stability. The knife is stabilized
exactly, where the highest cutting forces are
applied. Full use of the knife length
.
Assembling the „RS“ type Knife Holder on the base of the Knife Holder
Release clamping lever in opposite direction to that of the arrow.
Introduce the „RS“ type knife holder into the clamping mechanism.
Clamp at the required clearance angle position.
Inserting the blade
Slightly unscrew clamping screws.
Lift the valve completely bent up.
Insert the blade and adjust with the knife height adjustment device the blade-edge to
the white strip.
Fit the valve and clamp it evenly with the two clamp screws.
Open the blade guard
Move the movable protection for opening outwards. Finger-blade guard when setting
always closed hold.
To Next Page
Loading...