microTec
34
8.5 Holder for Throw-away Blades
Assembling the holder for throw-away blades on the base for the knife holder.
Release clamping lever in opposite direction to that of the arrow.
Introduce the holder of the throw-away blades into the clamping mechanism.
Clamp at the required clearance angle position.
Inserting the throw-away blades
Release clamping lever.
Insert throw-away blades from the side in the gap between the bars and the clamping
plate.
Push throw-away blades to the center of the throw-away blade holder.
Tighten clamping lever.
Suitable Knife blades
Blades type Manufacturer Dimensions
ACCU-EDGE FEATHER 0,25 x 8,0
ACCU-EDGE FEATHER 0,32 x 14,1
Inscription of clamping plate
MS24, MS33, MS100, MS200, MS300 MICROS Austria 0,25 x 8,0 CUT 2511A Low Profile I
EDGE-RITE Thermo Scientific 0,30 x 8,0 CUT2511AE Low Profile I
Plasma High Profile MICROS Austria 0,32 x 14,0 CUT 2511B High Profile I
Fig. 17
Holder for throw-away blades
Space for inscription
Fig. 17
Base for the knife holder
To Next Page
Loading...