Microtek ArtixScan 120tf User Manual

12 ArtixScan 120tf Installation and Operation Manual
Using the 6 x 9 cm Filmstrip Holder
The 6 x 9 cm filmstrip holder allows you to scan varying sizes of transparencies,
including 6 x 4.5 cm, 6 x 6 cm, 6 x 7 cm, and 6 x 9 cm. The maximum number of film that
can be loaded depends on the size of your film (e.g., the 6 x 4.5 cm can hold up to 4
pieces of film; 2 pieces for the 6 x 9 cm film).
1. Push to open the holder.
2. Flip the 35mm filmstrip face down and place it into the holder and ensure that the
filmstrip’s edge is against the side of the holder.
3. Close the holder lid and lock it by sliding it toward the side (indicated by an arrow
mark).
1
1
1
6x4.5cm
6x6cm
6x9cm
6x7cm
1
2
2
2
3
3
2

Microtek ArtixScan 120tf Specifications

Power

voltage	AC 90V to 264V, 47-63 Hz

Operating Environment

operating temperature	50° to 95°F (10° to 35°C)
relative humidity	20% to 80%

Scanning Specifications

scanning area	6 x 9 cm Max., 6 x 7 cm, 6 x 6 cm, 6 x 4.5 cm, 25 x 38 mm
resolution optical	4, 000 dpi x 4, 000 dpi
resolution interpolated	16, 000 dpi x 16, 000 dpi

Interfaces

firewire ports	Two
scsi ports	Two
transmission speed firewire	4 Mbytes/s
transmission speed scsi	2 Mbytes/s

Weight and Dimensions

dimensions	19.8" x 10.8" x 5.5" (504 x 274 x 142 mm)
weight	17.6 lb (8 kg)