Microtest CT-8750 - Page 39

CT-8750 User’s Guide
P 38
(p) In this item, use the alphanumeric to setup stand value as weel
(q) After, useS1[Ω]/S2[KΩ]/S3[MΩ] to select a unit of Std-Val unit
(r) Press[Enter] to confirm, cursor will move to “Tol%” display as following
(s) Use alphanumeric to setup tolerate
(t) Use S1[>=STD]/S2[<=STD]/S6[ALL SAME] to shift tolerate setup
(u) Following this way to setup test condition what you needed, LCD display as
following
(v) Press [ Enter ] to confirm, LCD display as following