Flooded type water cooled screw chiller (PCB Control) MCAC-CTSM-2012-11
31
Mode Setting Page
【Mode Setting Page】
Control mode and working mode are to be set in this page:
1. Control mode and running mode which have been selected currently for units are displayed here,
and this position will correspondingly vary according to the choices of customers when selection of
modes is changed.
2. Selection of unit control modes, including three modes: “LOCAL”, “REMOTE”, “TIMED”, i.e. local
control, remote control, timing control.
3. Selection of unit operation modes, including three modes: “PUMP”, “COOLING”, “HEATING”, i.e.
pump mode, cooling mode, heating mode.
4. Selection of compressor, including three modes: “DUAL”, “NO.1”, “NO.2”,
5. Click on “PgDn” to enter the next page (Main Page).
6. Click on “BACK”, return to the homepage of units.
Note:
① The control mode and running mode can be selected optionally in standby status, while only the
control mode can be switched in running status.
② Control Mode: The selection of the ways of Unit starting/stopping. “LOCAL” indicates you can only
start or stop the unit through “Start/Stop” button in touch screen. “REMOTE” indicates you can only
Password Input Page
5
3
2
1
4
To Next Page
Loading...
