Midea SO-BD386WE-UT - Display and Main Control Panel; Bar Counter(None); Water Dispenser(None)

Service manual, 2016-12
26 / 42
4. Remove the starter and protector
Unplug the starter and protector (you can use a
screwdriver to pry it slowly)
5. The reverse process can complete installation.
/
8.7Display and main control panel
Display
1)use slotted screwdriver to prize up the display
PCB assembly slightly, to get the display PCB
assembly
2)use cross screwdriver to remove the 4 pcs screws,
to dismantle the display PCB
3)Unplug the wiring connector, change the display
PCB, the reverse operation is for assembly
main control panel
1) Use cross screwdriver to remove the 2 screws, to
get the main PCB assembly
2) Use slotted screwdriver to prize up the cover of
main PCB box slightly
3) Use cross screwdriver remove the 1 pc screw of
main PCB,and dismantle the main PCB
4) Unplug the wiring connector,change the main
PCB, the reverse operation is for assembly
8.8 Bar counter(None)
Disassembly and installation of bar counter
None
Disassembly and installation bar doorseal
None
8.9 Water dispenser(None)
Disassembly and installation of water valve
None
Disassembly and installation of water tank
None