Midland Base Tech III - Firmware Error Detection; RS232 Error Detection

Base Tech III Operating Manual
21
34) DSP error detection
When DSP does not work properly, the following message are shown
on the LCD. Please check DSP board is firmly connected, or replacing the DSP board.
Figure-46 shows DSP failure
Figure-47 shows DSP not ready
Figure-48 shows DSP serial error
RX
TX
C001 Channel
DSP Failure!
Figure 46
RX
TX
C001 Channel
DSP not ready
Figure 47
RX
TX
C001 Channel
DSP serial Err!
Figure 48