Midland CT2000 - Other functions; Setting the Time Out Timer:

Midland CT2000 instruction guide | 25
Other functions
Activating/deactivating the keypad tones
• Press FUN + [0] to enable/disable the keypad beep tones.
• When the keypad tones are activated, the display will show l’icona
1
2
3
4 7 10
12
118956
2
3
4
5
6
1
13
14
15
.
Setting the Time Out Timer:
The time out timer (TOT) automatically switches the radio in reception if you talk
for too long, after a pre-set time that can change from 1 minute up to 30 min.
Before stopping the transmission, CT2000 emits an acoustic alarm to warn you.
We suggest you keeping this function enabled.
Note: TOT can be adjusted also from the radio menu.
Access the radio menu and follow this procedure:
• MENUUtilitiesRadio SettingTOT
• Set the desired time and confirm with MENU or PTT controls.
• Press FUN to exit the menu and return in stand-by mode.
Activating/deactivating the keypad lock:
Press FUN + [5] to enable or disable the keypad lock.
Or you can also push F and then Lo on the front panel of the radio.
Display backlight
The display backlight can be adjusted in 3 dierent levels:
• ON: backlight always on;
• 5S: backlight turns o after 5 seconds;
• 10S: backlight turns o after 10 seconds.
• Press FUN + [7]. Select the desired level. Press PTT for confirmation or
wait for 5 seconds.
• The backlight label can be adjusted also through the radio menu; follow this
path: MENUUtilitiesRadio SettingBack Light
Auto power-o
You can set the automatic turning o for CT2000.
• Enter the radio menu and follow this procedure:
MENUUtilitiesRadio SettingAuto Power O
• Set the desired level: 30/60/120 minutes and confirm by pushing MENU
or PTT.
• Press FUN to exit the menu and return in stand-by mode.