Midland CT2000 User Manual

Midland CT2000 instruction guide | 27
Secondary display
In CT2000 it is possible to use also the secondary display “VFO B” (upper
part) for some functions:
• To display the frequency of the secondary VFO;
• To display the voltage
• You can disregard the secondary display and use only the main one.
• Enter the menu and follow these steps:
MENUUtilitiesRadio SettingSub Screen
• Now choose amongst:
. OFF
. Frequency
. Voltage
• Select the desired setting and confirm with MENU or PTT.
• Press FUN to exit the menu and return to stand-by condition.
Buttons on the front panel of the radio
CT2000 allows to assign functions to the buttons on the front panel of the
radio (Pw, Mz, CT, V/M e A/B).
• Enter the menu and follow these steps:
MENUUtilitiesRadio SettingKeyFun Pw (or KeyFun Mz, KeyFun
CT, KeyFun V/M o KeyFun A/B)
• Now choose amongst the following functions:
. A/B,
. LOW,
. MONI,
. SCAN,
. TONE,
. M/V,
. MHz,
. MUTE
• Set the desired option and confirm by pushing MENU or PTT.
• Press FUN to exit the menu and return to stand-by condition.
Note: The default setting of these buttons is the following:
• Pw: LOW, quick selection of the tx power;
• Mz: MHz, quick change of the frequency (MHz digit);
• CT: TONE, quick selection of the CTCSS/DCS tones in tx and/or rx;
• V/M: M/V, quick selection of the frequency and channel mode.
• A/B: A/B, quick selection of band A or B.

Midland CT2000 Specifications

General

Brand	Midland
Model	CT2000
Category	Transceiver
Language	English