Model MXT100
4. Press the Volume Up or Volume Down button to increase or
decrease radio volume.
5. Once the radio volume has been adjusted to the desired level, press
the Monitor/Quiet Channel
button to exit Monitor mode.
Scanning for Active Channels
Your MXT100 includes an “auto-scan” mode that continuously scans all 15
available channels for activity. Additionally, if desired, you can remove one
or more channels from the list of scanned channels.
To enter and exit “auto-scan” mode:
1. Be sure the radio is turned on (see Power On/Off).
2. Quickly press and release the Scan
button to enter “auto-scan”
mode.
The Scanning icon will show on the LCD display when the radio
is in “auto-scan” mode.
Your radio will rapidly scan through the 15 available channels and
will pause on any active channel.
“Auto-scan” will resume when there has been no activity on the
current channel for four seconds.
3. To transmit during “auto-scan,” press and hold the PTT button on the
microphone while the radio is paused on the desired channel.
The radio will remain on the active channel for three seconds after
the PTT button is released.
4. To exit the “auto-scan” mode, quickly press and release the Scan
button.
The Scanning icon will turn off when the radio is no longer in
“auto-scan” mode.
To remove a channel from “auto-scan” mode:
1. Be sure the radio is turned on (see Power On/Off).
2. Use the Channel Up
or Channel Down button to scroll forward
or backward through the available channels until the Channel icon for
the channel you wish to remove shows on the LCD display.
midlandusa.com Page 15
To Next Page
Loading...
