Model MXT100
5. When the desired “beep” tone volume level is shown on the LCD
display, press the Menu
button (or wait 3 seconds) to confirm your
selection.
Selecting the Transmit (TX) Power Level
The MXT100 provides two transmit power levels; HI and Lo. The Lo
power level is generally suitable when operating under optimum conditions
(see About Range). The HI power level is recommended to ensure you
get maximum range from your radio.
To adjust the transmit power level:
1. Press the Menu
button to place the radio in “Menu” mode.
2. Use the Channel Up
or Channel Down button to scroll the
menu options until the LCD display shows F5.
3. Press the Menu
button again to confirm your selection.
4. Use the Channel Up
or Channel Down button to toggle the
transmit power setting between HI and Lo.
5. When the desired transmit power level is shown on the LCD display,
press the Menu
button to confirm your selection. YOU MUST
PRESS THE MENU BUTTON TO CONFIRM YOUR SELECTION
OR THE POWER LEVEL WILL NOT BE CHANGED.
RESTORING THE DEFAULT SETTINGS
You can restore the original (factory default) settings for your MXT100 at
any time.
To restore the default settings:
1. Be sure the radio is turned off (see Power On/Off).
2. Press and hold the Volume Up
button.
3. Press and hold the Power On/Off
button for two seconds to turn the
radio on.
4. Release both buttons.
To Next Page
Loading...
