www.midtronics.com
1 – Introduction & Overview
DCA-8000
13
Safety Reminder
For safe, ecient, and accurate charging and testing, review the safety and operating instructions
in this manual before using the analyzer. In addition, follow all manufacturer instructions and BCI
(Battery Council International) safety recommendations.
Safety Precautions
Inspect the battery for damages and check the electrolyte level. If the electrolyte level is too low,
replenish it and fully charge the battery. Always use the necessary safety precautions when working
with batteries to prevent severe injury or death. Follow all manufacturers’ instructions and BCI
(Battery Council International) safety recommendations, which include the following precautions:
Risk of explosive gases.
Never smoke or allow a spark or
ame in the vicinity of a battery.
Batteries can produce a highly explosive
mix of hydrogen gas and oxygen, even
when the battery is not in operation.
Always work in a well-ventilated area.
Wash hands after handling.
REQUIRED BY CALIFORNIA PROP. 65: Battery
posts, terminals, and related accessories contain
lead and lead compounds, chemicals known to
the state of California to cause cancer and birth
defects or other reproductive harm.
9 Battery acid is highly corrosive. If acid enters your eyes, immediately ush them thoroughly
with cold running water for at least 15 minutes and seek medical attention. If battery acid
gets on your skin or clothing, wash immediately with a mixture of water and baking soda.
9 Always wear proper safety glasses or face shield when working with or around batteries.
9 Keep hair, hands, and clothing as well as the analyzer cords and cables away from moving
engine parts.
9 Remove any jewelry or watches before you start servicing the battery.
9 Use caution when working with metallic tools to prevent sparks or short circuits.
9 Never lean over a battery when testing, charging, or jump starting.
9 Never charge a frozen battery. Gases may form, cracking the case, and spray out battery acid.
Manual Conventions
This manual uses these symbols and typographical conventions:
Symbol Description
The safety symbol indicates instructions for avoiding
hazardous conditions and personal injury.
The safety symbol with the words CAUTION, WARNING,
or DANGER indicates instructions for avoiding hazardous
conditions and personal injury.
The wrench symbol indicates procedural notes and helpful
information.
These symbols indicate which arrow keys on the keypad to
press for a given function.
Bold Letters
The text for screen options are in Bold letters.
1 – Introduction & Overview
To Next Page
Loading...
