Midtronics DCA-8000

www.midtronics.com
10 – Reash
DCA-8000
45
10 – Reash

Use Reash to test and maintain battery voltage in a vehicle at 13.5 volts to allow
for uninterrupted reprogramming of vehicle’s computer, retain vehicle system
settings, or simply to maintain battery voltage.
At any time during the test tap  to return to the previous screen or to return to the Main Menu.
1. Connect the Diagnostic Device test clamps to the battery.
2. At the Main Menu tap Reash. The Reash screen is displayed.



Flooded
Rated Ah




CCA



NOTE: See Appendix B for complete parameter descriptions.
3. Enter the battery information and reashing parameters.
If the displayed information is correct, tap Start Reash to begin.
The charger goes through a series of steps to determine the overall condition of the battery
before applying reash power. Those steps include measuring ambient temperature, Cranking
Health, Reserve Capacity, Charge Acceptance, and applying a Load Test on the battery.



 
 
 
 
  F
Send Results
Done
The test results are displayed on the charger screen.
To send the test results to a congured printer or via email tap Send Results and select an option.
To return to the Home Screen, tap Done or to return to the Main Menu.