www.midtronics.com
5 – Jump Start
DCA-8000
29
5 – Jump Start
Jump Start
Use the Battery Diagnostics function to perform a deep analysis of a battery
without charging it.
This charging mode makes high output current available to boost charge an in-vehicle battery as
well as assist in starting the engine. Press STOP to abort at any time.
IMPORTANT:
Before entering the Jump Start Mode, verify that all vehicle loads are o
and the key is not in the ignition.
At any time during the test tap to return to the previous screen or to return to the Main Menu.
1. Connect the charger clamps to the appropriate battery posts.
2. At the Main Menu tap Jump Start. The Jump Start screen is displayed.
Jump Start
Flooded
Rated Ah
CCA
Begin Jump Start
3. Tap the box across from each displayed parameter and select the correct information from
the displayed list.
4. Tap Begin Jump Start to begin the Jump Start process.
The charger performs a series of tests to determine the overall condition of the battery before
applying a boost charge to the battery.
IMPORTANT:
Do not crank the engine during the boost charging process.
NOTE: The maximum charge time is 10 minutes.
NOTE: The charger will not boost charge a battery that has tested unsafe.
5. Following a successful boost charge, the charger displays CRANK ENGINE NOW. The engine
can now be cranked the engine for up to ve seconds.
6. When the charger displays “JUMP START COMPLETE,” press STOP key. (The warning tone
sounds every second until you press STOP.)
To Next Page
Loading...
