Installation, repairs and other work by unqualified persons
could be dangerous.
Preparing the appliance
Before installing and connecting the appliance, see "Water
connection".
Installing the water intake hose
The water intake connection is located on the rear panel at
top left.
^
Place the union nut on the threads of the stainless steel
tubing.
Ensure a firm and tight seating of the fitting.
Installing the drain hose
The drain connection is located on the rear panel at bottom
left.
^ Attach the hose to the drain connection on the appliance
and secure it with the hose clamp.
Inserting and connecting the appliance
^ Connect the power cord to the appliance.
^
Run the water intake and drain hoses through the cut-out in
the appliance support plate.
^
Slide the appliance in and align it.
Make sure that the power supply cable and water hoses
are not pinched or damaged.
The device must be level, so that the steam generator can
operate properly.
Deviation from the horizontal should not exceed 2°.
Installation and connection
152
To Next Page
Loading...
