Cleaning and care
91
Starting the descaling process
Select Other.
Select Maintenance.
Select Descale.
If the functions and Automatic
programmes that use moisture
injection are already disabled, the
descaling process can be started
immediately by touching OK.
Place the universal tray on the top
shelf level to collect the descaling
solution after it has been used.
Confirm the message shown with OK.
Attach one end of the plastic tube to
the water intake pipe.
Place the container with the
descaling solution on the floor of the
oven.
Place the other end of the plastic
tube in the bottom of the descaling
agent container and secure the
plastic tube to the container with the
suction cup.
Confirm with OK.
The water intake process will begin. You
will hear the noise of the pump.
You can interrupt and resume the
intake process at any time by
selecting OK.
A message will appear when the intake
process is finished.
Confirm with OK.
Provide 1l of fresh tap water and
follow the instructions in the display.
The activation phase will begin. You
can follow the duration as it counts
down.
Leave the container with the tube
connected to the water intake pipe in
the oven compartment.
The system will take in liquid several
times during the activation phase. You
will hear the noise of the pump.
The oven lighting and the cooling fan
will remain on during descaling.
A buzzer will sound at the end of the
activation phase.
Rinsing the steam injection system
after the activation phase
After the activation phase, the steam
injection system must be rinsed out
with cold tap water to remove residues
of descaling agent.
Cleaning is carried out by flushing
approx. 1litre of fresh tap water
through the system three times. The
water is collected in the universal tray.
Rinse the container thoroughly after
the first rinse to remove any descaling
agent residue.
Follow the instructions in the display.
To Next Page
Loading...
