Cleaning and care
92
After the third rinse, the pump will run
for approx.1minute to pump the
remaining water out of the steam
injection steam.
Follow the instructions in the display.
Remove the universal tray, container
and plastic tube.
Confirm with OK.
The rinsing process is complete.
Evaporating residual moisture
After the third rinse, residual moisture
evaporation and the drying process will
commence.
Close the door.
Danger of injury caused by
steam.
Steam can cause scalding.
Do not open the door while the
residual moisture is being
evaporated.
The oven heating will switch on and the
duration of the evaporation process will
count down in the display. During the
evaporation process, the duration may
be adjusted by the system according to
how much water is currently present.
Once the residual water has been
evaporated, the drying process starts
automatically to remove moisture from
inaccessible areas of the oven
compartment.
Finalising the descaling process
At the end of the evaporation process a
message will appear in the display with
advice on cleaning after running the
descaling programme.
Confirm with OK.
A buzzer sounds and Finished appears.
Use the On/Off sensor to switch
the steam combination oven off.
Risk of injury caused by hot
surfaces.
The steam combination oven gets
hot during operation. You could burn
yourself on the heating elements, the
oven compartment, or accessories.
Allow the heating elements, oven
compartment and the accessories to
cool before manual cleaning.
When the oven compartment has
cooled down, clean away any
descaling agent residues.
Leave the oven door open until the
oven compartment is completely dry.
To Next Page
Loading...
