Operation
30
Operating principles
This ceramic cooktop is equipped with
electronic sensor controls which react
to finger contact. For safety reasons, in
order to switch the cooktop on, the On/
Off sensor needs to be touched for a
little longer than the other sensors.
Each time you touch a sensor, an
audible tone sounds.
Only the printed On/Off symbol is
visible when the cooktop is switched
off. More sensors light up when the
cooktop is switched on.
Malfunction due to dirty and/or
covered sensors:
If the sensors are dirty or covered,
this could cause them to fail to react,
to activate a function or even to
switch the cooktop off automatically
(see “Safety switch-off”). Placing hot
pans on the sensors/indicators can
damage the electronic unit
underneath.
Keep the sensors and indicators
clean and do not place anything on
top of them. Do not place hot pans
on them.
To Next Page
Loading...
