Miele KMDA 7774 - Miele@Home;Con@Ctivity; Signing on the Cooktop; Signing off the Cooktop

Miele@home/Con@ctivity
58
Signing on the cooktop
To sign the cooktop onto Miele@home,
prepare the logging-on process on the
master appliance.
 With the cooktop switched off,
press and hold the  and  sensor
controls together until the symbol
lights up and  appears in the timer
display.
After a few seconds : (Programme
01) will flash alternately with : (Code)
in the timer display.
 While : is visible in the display,
touch the sensor control as often
as necessary until: (Programme
P:10) is displayed.
 While : is visible in the display,
touch the sensor control as often
as necessary until: is displayed.
The signing-on process will begin and a
scrolling bar will appear in the display.
The signing-on process will take a few
minutes. Once the process has been
completed successfully, :will light
up in the display.
 If the signing-on process is not
completed successfully, repeat the
process.
 While : is visible in the display,
touch the sensor control until the
indicators go out to save the setting.
 Finish the signing-on process on the
master appliances (see the
appropriate instructions).
Signing off the cooktop
If you want to sign the cooktop off from
Miele@home, first carry out the signing
off procedure on the master appliance.
 With the cooktop switched off,
press and hold the  and  sensor
controls together until the symbol
lights up and  appears in the timer
display.
After a few seconds : (Programme
01) will flash alternately with : (Code)
in the timer display.
 While : is visible in the display,
touch the sensor control as often
as necessary until: (Programme
P:10) is displayed.
 While : is visible in the display,
touch the sensor control as often
as necessary until: is displayed.
The signing-off process will begin and a
scrolling bar will appear in the display.
The signing-off process will take a few
minutes. Once the process has been
completed successfully, :will light
up in the display.
 If the signing-off process is not
completed successfully, repeat the
process.
 While : is visible in the display,
touch the sensor control until the
indicators go out to save the setting.