x
Note
If the nozzle was run over smooth flooring (e.g., parquet or tile) while in the
“Automatic” setting, the motor will run at its highest speed due to the air coming
in at the sides of the nozzle.
Cause
Pressure sensor on the electronic board is defective.
Remedy
A Pull off the hose between the control panel and the dust compartment lid (040
Fig. 5, Pos. B).
A Switch the motor on in the "Automatic" setting.
A Generate a low-pressure condition at the disconnected end of the hose (e.g.,
quickly suck an object in).
A If the motor speed does not drop, then the pressure sensor is defective.
A Replace the electronic.
Descriptive Technical Documentation
DTD no. 41-8000 040-7
07.06.2013, US_am This information should not be duplicated or passed on without Miele approval. All rights reserved.
To Next Page
Loading...
