4 Service
4.1 Motor/Cord Reel Cover Removal
A Cover Frame Removal, 020 4.2.
A Operating Unit Removal, 040 4.1.
A Remove the T20 screw at the front of the motor cover (050 Fig. 2, Pos. 1).
A Remove the motor cover as one piece.
x
Fig. 2
4.2 Motor Replacement
A Motor/Cord Reel Cover Removal, 050 4.1
A Disconnect the Molex plug from the motor.
A Lift the motor straight out of the base.
A Remove the white plastic motor bracket from the motor casing, along with the
two rubber cushions.
A Use a flathead screwdriver to release the three clips holding the two casing
halves together.
A Separate the casing halves and take out the motor.
A Reinstall by following these instructions in reverse order.
x
Note
When reassembling, make sure that the motor wiring and the plug connection to
the operating unit are correctly installed in their guides.
Descriptive Technical Documentation
050-6 DTD no. 41-8000
This information should not be duplicated or passed on without Miele approval. All rights reserved. 07.06.2013, US_am
To Next Page
Loading...
