Miele S 8530 - Cord Reel Replacement; Pre-Motor Filter Frame Removal

4.3 Cord Reel Replacement
Note
The cord reel and cord form one assembly and can only be replaced together.
A Cover Frame Removal, 020 4.2.
A Operating Unit Removal, 040 4.1.
A Release the right and left sides of the cord reel and lever the cord reel out,
using a flathead screwdriver as necessary.
A Reinstall by following these instructions in reverse order.
x
Note
When re-installing the cord reel, make sure that the seal on the motor/cord reel
wiring harness is installed correctly in its groove on the motor seal before
pressing the cord reel assembly into place.
4.4 Pre-Motor Filter Frame Removal
A Take out the cord reel, referring to Cord Reel Replacement, 050 4.3 as
necessar y.
A Remove the parking slot screw (T20) on the motor side and take out the
parking slot.
A Open the pre-motor filter frame.
A Press in on the blue pins (one was obscured by the cord reel and the other by
the parking slot) using a suitable tool.
Descriptive Technical Documentation
DTD no. 41-8000 050-7
07.06.2013, US_am This information should not be duplicated or passed on without Miele approval. All rights reserved.