EasyManuals Logo

Miele S2 Series User Manual

Miele S2 Series
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
Technical Information
33
S2 Canister Vacuums
Note:
The motor protection filter should always be changed when a new pack of
Miele vacuum bags is opened. A motor protection filter is supplied with every
pack of Miele vacuum bags.
Cause:
Exhaust filter clogged.
Remedy:
Replace the exhaust filter.
Note:
1. Super Air Clean
This exhaust filter should always be changed when a new pack of Miele
vacuum bags is opened. A Super Air Clean exhaust filter is supplied with
every pack of Miele vacuum bags.
2. Active Air Clean - Active HEPA
This exhaust filter must be changed after approximately 1 year. The date
can be written on the filter.
4 Service
4.1 Telescopic Suction Hose Locking Piece Replacement
1. Release the old locking piece with a small flathead screwdriver.
2. Remove the cap (Figure 040-2, Item A). The pushbutton and spring
underneath will be released as well.
3. The insert (Figure 040-2, Item B) will also come out when the locking
piece is removed.
Figure 040-2: Telescopic Locking Piece
Note:
When re-installing, carry out the following in the given order:
1. Install the pushbutton, Figure 040-2, Item A.
2. Press and hold the pushbutton while sliding the insert (Figure 040-2, Item
B) into the suction hose.
The insert can be replaced separately, if needed.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele S2 Series and is the answer not in the manual?

Miele S2 Series Specifications

General IconGeneral
BrandMiele
ModelS2 Series
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals