Changing factory default
settings
Settings can only be changed when
the oven is switched on and the
rotary selector is at ß.
Your appliance is supplied with a
number of standard default settings
(see the "Settings overview" chart).
A setting is changed by altering its
status.
^
Touch X.
^ If necessary, use the rotary selector
to move the triangle V until it
appears under X.
P
X+ 0
V
^ Touch the OK sensor.
Piwill appear:
Pi
^
If you wish to change another setting,
use the rotary selector to select the
appropriate number.
^
Touch the OK sensor.
s0
The setting is selected and the current
status appears, e.g. S0.
To change the status:
^
Use the rotary selector to select the
status you want.
^
Touch the OK sensor.
The selected status is saved and the
setting appears again.
If you want to change further settings,
proceed as described above.
Touch # if you have not changed one
setting and wish to switch to another.
^ Touch X if you do not want to
change any more settings.
The settings remain in the memory
even after a power cut.
Settings
37
To Next Page
Loading...
