Miele WWB 020 - Extra White  X; Outdoor; Proofing - X; Drain;Spin

Program chart
33
Temperature
with garment care label
symbols
Item/Tip
Extra White Full load (17.6lb/8kg)
Hot+  140°F/60°C  For white fabrics made of cotton or linen
without special hygiene requirements.
Outdoor Small load (5.5lb/2.5kg)
Warm+  105°F/40°C  Performance outerwear (e.g. jackets and
trousers) made from membrane fabric such as
Gore-Tex®, SYMPATEX®, WINDSTOPPER®,
etc.
– Zip up or close any jackets with Velcro before
washing.
– Do not use fabric softener.
– If required, these garments can also be re-
proofed using the Proofing program. Proofing
after each wash cycle is not recommended.
Warm 85°F/30°C 
Cold Cold
Proofing Small load (5.5lb/2.5kg)
Warm+  105°F/40°C Treating microfibre fabric, ski wear, or table
linens made from mainly synthetic fibres to
provide a finish which is resistant to water and
dirt.
– The items should be freshly laundered and
spun or dried before proofing.
– For best results, the items should be heat-
treated afterwards. This can be achieved by
drying them in the tumble dryer or ironing
them.
Drain/Spin Full load (17.6lb/8kg)
Cold – Drain only: Set spin speed to.
– Make sure you select the appropriate spin
speed.