Miele WWB 020 - Cancellation and fault indicators

Frequently asked questions . . .
45
The program is cancelled and a fault indicator light lights up on
the control panel
Problem Possible cause and solution
The fault indicator
light lights up,
and appear
alternately on the time
display, and the buzzer
sounds.
The water inlet is blocked or restricted.
 Check whether the tap is turned on properly.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The fault indicator
light lights up,
and appear alternately
on the time display, and
the buzzer sounds.
The drain is blocked or restricted.
The drain hose has been fixed too high.
 Clean the filter and the pump.
 The maximum drain height is 1m.
The fault indicator
light lights up,
and appear
alternately on the time
display, and the buzzer
sounds.
The water protection system has reacted.
 Close the tap.
 Contact the Service department.
and appear
alternately on the time
display and the buzzer
sounds.
There is a fault.
 Disconnect the washing machine from the
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by
disconnecting it at the circuit breaker.
 Wait at least 2 minutes before reconnecting the
washing machine to the electricity supply.
 Then switch the washing machine on again.
 Restart the program.
If the fault message appears again, contact the
Service department.