Miele WWB 020 - Programmable functions; Accessing and navigating settings

Programmable functions
70
The programmable functions are used
to alter the machine’s electronics to
suit changing requirements.
Programmable functions can be
altered at any time.
Programming is carried out in 8 steps
(, , ... ) using the sensor
buttons.
Accessing the programming level
Before you begin, ensure the following:
– The washing machine is switched on
(the program selector is pointing to a
wash program).
– The washing machine door is open.
 Touch the Start/Stopsensor button
and hold it down during steps–.
 Close the washing machine door.
Wait until the Start/Stopsensor button
lights up constantly...
 ...and then release the Start/
Stopsensor button.
After approximately4seconds,will
light up on the time display.
Choosing and selecting
programmable functions
The number of the programmable
function will appear on the time
display as and a number: e.g..
 Touch theorsensor button to
scroll to the next or previous
programmable function:
Programmable functions
 Buzzer
 Keypad tone
 PIN code
 Control panel switch-off status
 Memory
 Water inlet
 Additional long prewash –
Normal
 Gentle action
 Reduce temperature
 Maximum rinse level
 Suds cooling
 Anti-crease action
 Low water pressure
 Chlorine bleach
 Display brightness dimmed
 Welcome tone volume
 Confirm the selected programmable
function by touching the Start/
Stopsensor button.