Miele WWB 020 - Page 48

Frequently asked questions . . .
48
General problems with the washing machine
Problem Possible cause and solution
Fabric softener is not
completely dispensed
or too much water
remains in the 
compartment.
The siphon tube is not correctly positioned or
clogged.
 Clean the siphon (see “Cleaning and care –
Cleaning the detergent dispensing drawer”).
At the end of the
program there is still
liquid in the capsule.
The small pipe in the detergent dispenser drawer onto
which the capsule is placed is blocked.
 Clean the small pipe.
Not a fault.
For technical reasons, a small amount of water will
remain in the capsule.
There is water next to
the capsule in the fabric
softener compartment
The Capsensor button was not activated or an
empty capsule was not removed at the end of the last
wash cycle.
 Make sure that you remember to activate the
Capsensor button the next time you insert a
capsule.
 Remove and then dispose of the empty capsule at
the end of each wash cycle.
The small pipe in the detergent dispenser drawer onto
which the capsule is placed is blocked.
 Clean the small pipe.