Mikra M15 - Sensor Calibration

10
Sensor Calibration
A.
A.A.
A. Description: For better accuracy, please execute calibration immediately after
installed sensor each time.
Step 1. Fix sensor, keep 1mm gap from tape
(RECOMMENDED).
Step 2. Press
Target value display GO (Enter
parameter)
Step 3、Press and hold or to start.
※Note：Moving the slider at low speed, Required
distance around 120mm (Moving GO )
Display: GO (Detecting)
Display: GO (Almost complete)
When completed calibration, LED display will flash and
show.
Note: Please reload origin datum values refer to ※
page8.
GO
-
8 8 8 8 8 8
-
8 8 8 8 8 8
GO
9
9
F
8
9
Gap sensor-tape