OM-260430 Page 10
SECTION 3 – SPECIFICATIONS
3-1. Software Licensing Agreement
The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at
https://www.millerwelds.com/eula and are incorporated by reference herein.
3-2. Information About Default Weld Parameters And Settings
NOTICE – Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical
welding parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are
for reference purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriate-
ness of all parameters and settings should be evaluated and modified by the end user as necessary based upon application-specific require-
ments. The end user is solely responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld
parameters and settings, and ultimate quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warran-
ties including any implied warranty of fitness for a particular purpose.
3-3. Compatibility Information
Compatible Power Sources
Deltaweld Dimension Goldstar Invision XMT Alumapower
302 302 302 350 MPa 304 CC/CV 350 MPa
452 452 452 352 MPa 350 CC/CV 450 MPa
652 652 652 354 MP 350 MPa
1000 450 MPa 450 CC/CV
NT w/Arc Reach 456MP 450 MPa
NT 450 456P 456 CC/CV
650
Deposition is reported with 14 pin compliant welding power sources using MPa wire feeders.
Wirefeeders requiring 115 VAC are not compatible with this unit.
Units requiring High Frequency for TIG welding are not compatible with this unit. For information regarding Miller Power Sources
not included in the list, please call ISG Service at 920−954−3809.
Compatible SubArc Power Sources
SubArc Digital Series SubArc Series
DC 650 Digital* DC 650**
DC 800 Digital* DC 800**
DC 1000 Digital* DC 1000**
DC 1250 Digital* DC 1250**
AC/DC 1000 Digital* AC/DC 1000**
AC/DC 1250 Digital* AC/DC 1250**
Summit Arc 1000**
Summit Arc 1250**
*SubArc Digital Series power sources using a low voltage SubArc Interface Digital/Analog require a SubArc Digital Series to Insight
Core Adapter 301295.
**SubArc power sources using 115V Accessories, including the HDC 1500 Series controller, require a 115V to 14-Pin Adapter Cord
301259.
F
Please contact Miller for assistance in selecting the correct adapter for your needs.
To Next Page
Loading...
Need help?
General