Miller PipePro - User Manual

OWNER’S MANUAL
© 2007 MILLER Electric Mfg. Co.
OM-232 593C 2007−10
PipePro System Cart
1. Safety Symbol Definitions
Warning! Watch Out! There are possible hazards as
shown in the adjoining symbols.
Wear safety glasses with side shields.
Cylinders contain gas under high pressure and can ex-
plode if damaged. Never let a welding electrode touch
any cylinder. Always secure cylinder to running gear, wall,
or other stationary support.
Beware of electric shock from wiring. Disconnect input
power before installing this kit. Reinstall all panels and
covers.
Trailers
Falling equipment can cause serious personal injury and
equipment damage. Use lifting eye to lift unit only, not
trailer, gas cylinders, or any other accessories. Use
equipment of adequate capacity to lift unit or parts such
as engine or generator.
Running Gear
Falling equipment can cause injury and damage, over-
sized cylinder can cause tipping. Properly install and se-
cure all equipment onto cart before using cart. Always
secure or remove any tools stored on cart before moving
unit. Do not lift cart in any manner when equipment and
cylinder(s) are installed − use handles to move cart. Do
not overload handles with cables − use standard 10 to 15
foot cables as maximum lengths.
Tipping equipment can cause injury and damage
equipment. Do not move cart where two wheels are at
different heights and cart could tip − avoid tipping. Be
careful when moving unit over uneven surfaces.

Summary

Safety Symbol Definitions

General Hazard Warning

General warning about possible hazards indicated by adjoining symbols.

Eye Protection Required

Instruction to wear safety glasses with side shields.

Cylinder Handling and Securing

Safety precautions for high-pressure gas cylinders, including securing.

Trailer Equipment Safety

Warning regarding falling equipment when using trailers and proper lifting.

Running Gear Safety

Precautions for securing equipment on running gear and avoiding tipping.

Electrical Shock Prevention

Warning about electric shock and disconnecting power before installation.

Tipping Hazard Awareness

Caution about tipping equipment on uneven surfaces or different heights.

Installing Running Gear;Cylinder Rack

Cylinder Chain Installation

Instructions for installing cylinder chains to the bottle mounting bracket.

Installing PipePro Or Axcess Power Source Systems

Power Source Mounting

Mounting the power source to the cart using supplied nuts and bolts.

Cooler Installation

Mounting the cooler to the cart bottom pan with hardware.

Polarity Control and Bracket Installation

Installing polarity reversing/isolation control to mounting brackets.

Installing XMT 456 Power Source Systems

XMT 456 Power Source Mounting

Mounting the XMT 456 power source to the cart using supplied hardware.

Installing Wire Feeder

Wire Feeder and Stand-off Support Installation

Installing stand-off supports and attaching wire feeders to the cart.

Parts List

Miller PipePro Specifications

General

Brand	Miller
Model	PipePro
Category	Outdoor Cart
Language	English